Install Guide

DellEMC(conf-mon-sess-0)#source po 10 dest twentyFiveGigE 1/2 dir rx
DellEMC(conf-mon-sess-0)#do show monitor session
SessID Source Destination Dir Mode Source IP Dest IP DSCP TTL Drop
Rate Gre-Protocol FcMonitor
------ ------ ----------- --- ---- --------- -------- ---- --- ----
---- ----------- ---------
0 Tf 1/1 Tf 1/2 rx Port 0.0.0.0 0.0.0.0 0 0 No
N/A N/A No
0 Po 10 Tf 1/2 rx Port 0.0.0.0 0.0.0.0 0 0 No
N/A N/A No
DellEMC(conf)#monitor session 1
DellEMC(conf-mon-sess-1)#source vl 40 dest twentyFiveGigE 1/3 dir rx
DellEMC(conf-mon-sess-1)#flow-based enable
DellEMC(conf-mon-sess-1)#exit
DellEMC(conf)#do show monitor session
SessID Source Destination Dir Mode Source IP Dest IP DSCP TTL Drop
Rate Gre-Protocol FcMonitor
------ ------ ----------- --- ---- --------- -------- ---- --- ----
---- ----------- ---------
0 Tf 1/1 Tf 1/2 rx Port 0.0.0.0 0.0.0.0 0 0 No
N/A N/A No
0 Po 10 Tf 1/2 rx Port 0.0.0.0 0.0.0.0 0 0 No
N/A N/A No
1 Vl 40 Tf 1/3 rx Flow 0.0.0.0 0.0.0.0 0 0 No
N/A N/A No
NOTE: Source as VLAN is achieved via Flow based mirroring. Please refer section Enabling Flow-Based Monitoring.
In the following example, the host and server are exchanging traffic which passes through the uplink interface 1/1. Port 1/1 is
the monitored port and port 1/32 is the destination port, which is configured to only monitor traffic received on the 1/1 interface
(host-originated traffic).
Figure 102. Port Monitoring Example
Port Monitoring
645