Install Guide

- - - network rw ftp:
- - - network rw tftp:
- - - network rw scp:
- - - network rw http:
- - - network rw https:
DellEMC#show file-systems
Size(b) Free(b) Feature Type Flags Prefixes
520962048 213778432 dosFs2.0 USERFLASH rw flash:
127772672 21936128 dosFs2.0 USERFLASH rw slot0:
- - - network rw ftp:
- - - network rw tftp:
- - - network rw scp:
You can change the default file system so that file management commands apply to a particular device or memory.
To change the default directory, use the following command.
● Change the default directory.
EXEC Privilege mode
cd directory
View Command History
The command-history trace feature captures all commands entered by all users of the system with a time stamp and writes
these messages to a dedicated trace log buffer.
The system generates a trace message for each executed command. No password information is saved to the file.
NOTE:
The timestamps display format of the show command history output changes based on the service timestamps
log datetime configuration. The time format can be in uptime, local time zone time or UTC time.
If timestamp is disabled (no service timestamps log) then command history time format is shown with timestamp
defaults (service timestamps log datetime localtime).
To view the command-history trace, use the show command-history command.
Example of the show command-history Command
Example 1: Default configuration service timestamps log datetime or service timestamps log datetime
localtime
DellEMC(conf)#service timestamps log datetime
Example 2: service timestamps log datetime utc
DellEMC(conf)#service timestamps log datetime utc
Example 3: service timestamps log uptime
DellEMC(conf)#service timestamps log uptime
Example 4: no service timestamps log
DellEMC(conf)#no service timestamps log
DellEMC# show command-history
- Repeated 1 time.
[1d0h26m]: CMD-(CLI):[configure]by default from console
- Repeated 1 time.
[May 17 15:53:10]: CMD-(CLI):[no service timestamps log]by default from console
[May 17 15:53:16]: CMD-(CLI):[write memory]by default from console
- Repeated 3 times.
[May 17 15:53:22]: CMD-(CLI):[show logging]by default from console
- Repeated 1 time.
[May 17 15:53:36]: CMD-(CLI):[write memory]by default from console
- Repeated 5 times.
[May 17 15:53:44]: CMD-(CLI):[show logging]by default from console
Getting Started
53