Manualshelf

Install Guide

ManualsBrandsDell ManualsAccess PlatformsOS9
471472473474475476477478479480
Table Of Contents
Figure 67. Verifying LAG 10 Status on ALPHA Using the show lacp Command
Summary of the LAG Configuration on Alpha
Alpha(conf-if-po-10)#int twentyFiveGigE 1/3
Alpha(conf-if-tf-2/31)#no ip address
Alpha(conf-if-tf-2/31)#no switchport
Alpha(conf-if-tf-2/31)#shutdown
Alpha(conf-if-tf-2/31)#port-channel-protocol lacp
Alpha(conf-if-tf-2/31-lacp)#port-channel 10 mode active
Alpha(conf-if-tf-2/31-lacp)#no shut
Alpha(conf-if-tf-2/31)#show config
!
interface twentyFiveGigE 1/3
no ip address
!
port-channel-protocol LACP
port-channel 10 mode active
no shutdown
!
Alpha(conf-if-tf-1/3)#
interface Port-channel 10
no ip address
switchport
no shutdown
interface twentyFiveGigE 1/3
no ip address
Summary of the LAG Configuration on Bravo
Bravo(conf-if-tf-1/3)#int port-channel 10
Bravo(conf-if-po-10)#no ip add
474
Link Aggregation Control Protocol (LACP)