Administrator Guide

Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Added support for roles on the Z9000, S6000, S4820T, S4810, and MXL.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage
Information
Users entering EXEC Privilege mode or any other configured privilege level can access configuration
commands. To protect against unauthorized access, use the enable password command to configure
a password for the enable command at a specific privilege level. If no privilege level is specified, the
default is privilege level 15.
NOTE: If you are authorized for the EXEC Privilege mode by your role, you do not need to enter an
enable password.
Related
Commands
● enable password — configures a password for the enable command and to access a privilege level.
enable cpu-clock-monitor
Enables Intel CPU LPC (Low Pin Count) clock-failure monitoring.
Syntax
enable cpu-clock-monitor
To disable this feature, use the no enable cpu-clock-monitor command.
Parameters None
Defaults Enabled
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.11(2.0P1) Introduced on the C9010, S3048–ON, S6100–ON and Z9100–ON.
Usage
Information
Enables Intel CPU LPC (Low Pin Count) clock-failure monitoring and issues a warning syslog to the user
to take appropriate action if signal degradation is seen.
enable optic-info-update interval
Enable polling intervals of optical information updates for simple network management protocol (SNMP).
Syntax
enable optic-info-update [interval seconds]
94 Control and Monitoring