Release Notes
Table Of Contents
- Dell EMC S5048F–ON System Release Notes, OS Version 9.14(2.9P1)
- Document Revision History
- Requirements
- New Dell EMC Networking OS Version 9.14(2.9) Features
- Restrictions
- Changes to Default Behavior and CLI Syntax
- Documentation Corrections
- Deferred Issues
- Fixed Issues
- Known Issues
- Upgrading the ONIE Package for the S5048F-ON System
- Upgrading the DIAG Package for the S5048F-ON System
- Installing Dell EMC Networking OS on the S5048F-ON using ONIE
- Upgrading the CPLD
- Upgrading the SmartFusion Microcontroller Subsystem — SMF MSS-IAP
- Upgrading the SmartFusion Microcontroller Subsystem — SMF MSS-FPGA
- Upgrading the OOB-FPGA
- Upgrading the S5048F-ON Dell EMC Networking OS Image using Dell EMC Networking OS CLI
- Upgrade the Boot Selector and Boot Flash Images from Dell EMC Networking OS
- Uninstalling the Dell EMC Networking OS
- Installing a Third Party Operating System
- Support Resources
Severity: Sev 2
Synopsis: The PSU serial number displays as NA in the show inventory
command output for PSUs manufactured after January 2020.
Release Notes: The PSU serial number displays as NA in the show inventory
command output for PSUs manufactured after January 2020.
Workaround: None
PR# 169919
Severity: Sev 3
Synopsis: The switch may encounter a software exception due to invalid memory
access on bootup.
Release Notes: The switch may encounter a software exception due to invalid memory
access on bootup.
Workaround: None
PR# 169921
Severity: Sev 2
Synopsis: Static routes are not restored when BFD is disabled at interface level.
Release Notes: Static routes are not restored when BFD is disabled at interface level.
Workaround: None
PR# 169972
Severity: Sev 2
Synopsis: DHCPv6 relay-reply packet drops in the L2 VLAN when DHCPv6
relay is configured in the L3 VLAN.
Release Notes: DHCPv6 relay-reply packet drops in the L2 VLAN when DHCPv6
relay is configured in the L3 VLAN.
Workaround: None
PR# 169984
Severity: Sev 2
Synopsis: The switch may encounter a software exception when running the
show ipv6 ospf database router CLI command.
Release Notes: The switch may encounter a software exception when running the
show ipv6 ospf database router CLI command.
Workaround: None
Known Issues
Known issues are reported using the following definitions.
7