Release Notes

Verify that you need a CPLD upgrade
To identify the CPLD version, use the show revision command.
DellEMC#show revision
-- Stack unit 1 --
S5048F-ON CPLD 1 : 1.0
S5048F-ON CPLD 2 : 1.0
S5048F-ON CPLD 3 : 1.0
S5048F-ON CPLD 4 : 1.0
S5048F-ON MSS FPGA : 0.1
S5048F-ON MSS IAP : 1.4
S5048F-ON OOB-FPGA : 1.0
To view the CPLD version that is associated with the Dell EMC Networking OS image, use the following command:
DellEMC#show os-version
RELEASE IMAGE INFORMATION :
---------------------------------------------------------------------
Platform Version Size ReleaseTime
S-Series:S5048F-ON 9.14(2.9) 62789040 Dec 15 2020 13:53:48
TARGET IMAGE INFORMATION :
---------------------------------------------------------------------
Type Version Target checksum
runtime 9.14(2.9) Control Processor passed
BOOT IMAGE INFORMATION :
---------------------------------------------------------------------
Type Version Target checksum
boot flash 3.38.2.6 Control Processor passed
BOOTSEL IMAGE INFORMATION :
---------------------------------------------------------------------
Type Version Target checksum
boot selector 3.38.0.1-4 Control Processor passed
FPGA IMAGE INFORMATION :
---------------------------------------------------------------------
Card FPGA Name Version
stack-unit 1 S5048F-ON CPLD 1 1.0
stack-unit 1 S5048F-ON CPLD 2 1.0
stack-unit 1 S5048F-ON CPLD 3 1.0
stack-unit 1 S5048F-ON CPLD 4 1.0
stack-unit 1 S5048F-ON MSS FPGA 0.1
stack-unit 1 S5048F-ON MSS IAP 1.4
stack-unit 1 S5048F-ON OOB-FPGA 1.0
DellEMC#
Upgrading the CPLD Image
NOTE:
The upgrade fpga-image system cpld stack-unit 1 booted command is hidden when using the
feature in the CLI. However, it is a supported command.
To upgrade the CPLD image, follow these steps:
1. Shut down all of the interfaces on the system.
INTERFACE Mode
shutdown
18