Release Notes
Table Of Contents
- Dell EMC System S4048T–ON 9.14(2.9P1) Release Notes
- Document Revision History
- Supported Hardware
- Supported Software
- New Dell EMC Networking OS Version 9.14(2.9) Features
- Restrictions
- Changes to Default Behavior and CLI Syntax
- Documentation Corrections
- Deferred Issues
- Fixed Issues
- Known Issues
- Upgrading the sub-components
- Upgrading the ONIE Package for the S4048T-ON System
- Upgrading the DIAG Package for the S4048T-ON System
- Installing Dell EMC Networking OS on the S4048T-ON using ONIE
- Support Resources
Preparing /dev/sda3 EDA-DIAG for rootfs install
untaring into /tmp/tmp.jZpckM
rootfs copy done
Success: Support tarball created: /tmp/tmp.jZpckM/onie-support.tar.bz2
INSTALLER DONE...
Removing /tmp/tmp.a5Kpax
Rebooting...
ONIE:/ # discover: installer mode detected.
Stopping: discover...start-stop-daemon: warning: killing process 546: No such process
done.
Stopping: dropbear ssh daemon... done.
Stopping: telnetd... done.
Stopping: syslogd... done.
Info: Unmounting kernel filesystems
The system is going down NOW!
Sent SIGTERM to all processes
Sent SIGKILL tosd 4:0:0:0: [sda] Synchronizing SCSI cache
Restarting system.
machine restart
Installing Dell EMC Networking OS on the S4048T-ON
using ONIE
NOTE:
You will need the Dell EMC Networking OS installer package, ONIE-FTOS-SK-9.14.2.9.bin to install the Dell
EMC Networking OS on your S4048T-ON system that has only ONIE.
To install the Dell EMC Networking OS version 9.14(2.9) on a new S4048T-ON device, perform the following steps:
1. Reboot the system. During the reboot process, the system displays the following message prompting you to press the Esc
key in order to stop the auto-boot process:
Press Esc to stop autoboot ... 5
Grub 2.02~beta2 (Dell EMC Inc)
Built by root at ubuntu on Tue_Dec_15_13:04:17_UTC_2020
S4048T Boot Flash Label 3.27.2.10 NetBoot Label 3.27.2.10
2. At this prompt message, press the Esc key. The following menu appears:
GNU GRUB version 2.02~beta2+e4a1fe391
+----------------------------------------------+
|DELL |
|DELL-Boot Line Interface |
|DIAG-OS |
|ONIE |
| |
+----------------------------------------------+
Use the ^ and v keys to select which entry is highlighted.
Press enter to boot the selected OS, 'f' to boot FTOS, 'b' to go to
BLI, 'o' to boot ONIE, 'd' to boot DIAG-OS, 'e' to edit the commands
before booting or 'c' for a command-line.
3. From the menu, choose the ONIE option.
NOTE:
To choose an option from the menu, highlight one of the options using the up or down arrow key and press
Enter.
The following menu appears:
GNU GRUB version 2.02~beta2+e4a1fe391
17