Release Notes
Table Of Contents
- Dell EMC System S4048T–ON 9.14(2.9P1) Release Notes
- Document Revision History
- Supported Hardware
- Supported Software
- New Dell EMC Networking OS Version 9.14(2.9) Features
- Restrictions
- Changes to Default Behavior and CLI Syntax
- Documentation Corrections
- Deferred Issues
- Fixed Issues
- Known Issues
- Upgrading the sub-components
- Upgrading the ONIE Package for the S4048T-ON System
- Upgrading the DIAG Package for the S4048T-ON System
- Installing Dell EMC Networking OS on the S4048T-ON using ONIE
- Support Resources
========================================================================
Card Device Name Current Version New Version
------------------------------------------------------------------------
Unit1 S4048TON SYSTEM CPLD 12 12
Unit1 S4048TON MASTER CPLD 13 13
***********************************************************************
* Warning - Upgrading FPGA is inherently risky and should *
* only be attempted when necessary. A failure at this upgrade may *
* cause a board RMA. Proceed with caution ! *
***********************************************************************
Upgrade image for stack-unit 1 [yes/no]: yes
FPGA upgrade in progress!!! Please do NOT power off the unit!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Upgrade result :
================
Unit 1 FPGA upgrade successful Unit 1. Please power cycle to take effect.
DellEMC#Dec 15 06:35:00: %S4048T-ON:1 %DOWNLOAD-6-FPGA_UPGRADE: stack-unit 1 fpga
upgrade success.
DellEMC#
2. Power cycle the system physically. Switch off the system by unplugging the power chords from the REAR PSUs and wait
until the PSU FAN–REAR STATUS LED is completely OFF.
NOTE: Do not switch on the system with PSU–REAR LED glowing AMBER.
You can alternatively power cycle the switch using the power-cycle stack-unit <1-6> command as follows:
DellEMC#power-cycle stack-unit 1
Proceed with power-cycle? Confirm [yes/no]:yes
3. The CPLD version can be verified using show revision command output:
EXEC Privilege Mode
show revision
DellEMC#sh revision
-- Stack unit 1 --
S4048TON SYSTEM CPLD : 12
S4048TON MASTER CPLD : 13
DellEMC#
NOTE: Do not power off the system while FPGA upgrade is in progress. For any queries, contact technical support.
Upgrading the ONIE Package for the S4048T-ON System
To upgrade the ONIE package you have installed, use one of the following two processes: zero touch (dynamic) update or
manual update.
● Zero touch (dynamic): Copy the update ONIE installer for your system to the TFTP/HTTP server. Configure the DHCP
options using the ONIE specifications shown at the following link: https://github.com/opencomputeproject/onie/wiki/
Design-Spec-SW-Updating-ONIE.
● Manual: Copy the image onto the TFTP/HTTP servers and boot ONIE. Update the ONIE using the onie-self-update
command, then download and run an ONIE updater image (onie-updater-x86_64-s4048t_c2338-r0). The supported URL
types are: HTTP, FTP, TFTP, and FILE.
To upgrade ONIE, perform the following steps:
12