Release Notes
Table Of Contents
- Dell EMC System S4048–ON 9.14(2.9P1) Release Notes
- Document Revision History
- Supported Hardware
- Supported Software
- New Dell EMC Networking OS Version 9.14(2.9) Features
- Restrictions
- Changes to Default Behavior and CLI Syntax
- Documentation Corrections
- Deferred Issues
- Fixed Issues
- Known Issues
- Upgrading the sub-components
- Upgrading ONIE on the S4048-ON
- Upgrading the S4048-ON Dell EMC Networking OS Image using the Dell EMC Networking OS CLI
- Installing Dell EMC Networking OS on the S4048-ON using ONIE
- Uninstalling Dell EMC Networking OS from the S4048-ON
- Support Resources
* Warning - Upgrading FPGA is inherently risky and should *
* only be attempted when necessary. A failure at this upgrade may *
* cause a board RMA. Proceed with caution ! *
***********************************************************************
Upgrade image for stack-unit 1 [yes/no]: yes
FPGA upgrade in progress!!! Please do NOT power off the unit!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!
Upgrade result :
================
Unit 1 FPGA upgrade successful. Power cycle the Unit 1 to complete the upgrade.
DellEMC#00:22:35: %S4048-ON:1 %DOWNLOAD-6-FPGA_UPGRADE: stack-unit 1 fpga upgrade
success.
DellEMC#
2. Power cycle the system physically. Switch off the system by unplugging the power chords from the REAR PSUs and wait
until the PSU FAN–REAR STATUS LED is completely OFF.
NOTE: Do not switch on the system with PSU–REAR LED glowing AMBER.
You can alternatively power cycle the switch using the power-cycle stack-unit <1-6> command as follows:
DellEMC#power-cycle stack-unit 1
Proceed with power-cycle? Confirm [yes/no]:yes
3. The CPLD version can be verified using show revision command output:
EXEC Privilege Mode
show revision
DellEMC#show revision
-- Stack unit 1 --
S4048-ON SYSTEM CPLD : 15.2
S4048-ON MASTER CPLD : 12
S4048-ON SLAVE CPLD : 5
DellEMC#
NOTE: Do not power off the system while FPGA upgrade is in progress. For any queries, contact technical support.
Upgrading ONIE on the S4048-ON
To upgrade the ONIE package you have installed, use one of the following two processes: zero touch (dynamic) update or
manual update.
1. Zero touch (dynamic): Copy the updated ONIE installer and the DIAG installer for your system to the TFTP/HTTP
server. Configure the DHCP options using the ONIE specifications shown at the following link: https://github.com/
opencomputeproject/onie/wiki/Design-Spec-SW-Image-Discovery.
S4048-ON image >>>> onie-updater-x86_64-dell_s4000_c2338-r0.3.21.1.0-5
2. Manual: Copy the image onto the TFTP/HTTP servers and boot ONIE. Update the ONIE using the onie-self-update
command, then download and run an ONIE updater image.The supported URL types are: HTTP, FTP, TFTP, and FILE.
S4048-ON image >>>> onie-updater-x86_64-dell_s4000_c2338-r0.3.21.1.0-5
3. UPGRADING ONIE ON AN EXISTING S4048–ON SYSTEM.
11