Release Notes
Table Of Contents
- Dell EMC Z9100–ON System Release Notes, OS Version 9.14(2.10)
- Document Revision History
- Requirements
- New Dell Networking OS Version 9.14(2.10) Features
- Restrictions
- Documentation Corrections
- Changes to the Default Behavior and CLI Syntax
- Deferred Issues
- Fixed Issues
- Known Issues
- Upgrading the sub-components
- Upgrading the ONIE Package for the Z9100-ON System
- Upgrading the DIAG Package for the Z9100-ON System
- Installing Dell EMC Networking OS on the Z9100-ON using ONIE
- Upgrading the Z9100-ON Dell EMC Networking OS Image using Dell EMC Networking OS CLI
- Uninstalling the Dell EMC Networking operating system
- Installing a Third Party Operating System
- Support Resources
stack-unit 1 Z9100-ON CPLD 1 7
stack-unit 1 Z9100-ON CPLD 2 4
stack-unit 1 Z9100-ON CPLD 3 4
stack-unit 1 Z9100-ON CPLD 4 4
stack-unit 1 Z9100-ON MSS FPGA 2.2
stack-unit 1 Z9100-ON MSS IAP 2.5
stack-unit 1 Z9100-ON OOB-FPGA 1.0
DellEMC#
Upgrading the CPLD Image
NOTE: The upgrade fpga-image system cpld stack-unit 1 booted command is hidden when using the
feature in the CLI. However, it is a supported command.
NOTE: Ensure that the BIOS version is 3.23.0.0-9. You can verify this version using the show system stack-unit 1
command.
To upgrade the CPLD image, follow these steps:
1. Upgrade the CPLD image.
EXEC Privilege Mode
upgrade fpga-image system cpld stack-unit <id> booted
DellEMC#upgrade fpga-image system cpld stack-unit 1 booted
Current information for the system:
========================================================================
Card Device Name Current Version New Version
------------------------------------------------------------------------
Unit1 Z9100-ON CPLD 1 6 7
Unit1 Z9100-ON CPLD 2 4 4
Unit1 Z9100-ON CPLD 3 4 4
Unit1 Z9100-ON CPLD 4 4 4
***********************************************************************
* Warning - Upgrading FPGA is inherently risky and should *
* only be attempted when necessary. A failure at this upgrade may *
* cause a board RMA. Proceed with caution ! *
***********************************************************************
Upgrade image for system 1 [yes/no]: yes
FPGA upgrade in progress!!! Please do NOT power off the unit!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!May 18 16:16:54: %Z9100-ON:1 %DOWNLOAD-6-
FPGA_UPGRADE: stack-unit 1 fpga upgrade success.
Upgrade result :
================
Unit 1 FPGA upgrade successful Unit 1. Please power cycle to take effect.
DellEMC#
2. Power cycle the system physically. Switch off the system by unplugging the power chords from the Rear PSUs and wait until
the PSU Fan–Rear Status LED is OFF.
NOTE: Do not switch on the system with PSU–REAR LED glowing AMBER.
You can alternatively power cycle the switch using the power-cycle stack-unit <1-6> command as follows:
DellEMC#power-cycle stack-unit 1
Proceed with power-cycle? Confirm [yes/no]:yes
3. Verify the CPLD version using the show revision command output:
EXEC Privilege Mode
12