CLI Guide

Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.1 Introduced on the E-Series.
Example
DellEMC(conf-if-vl-100)# show config
!
interface Vlan 100
no ip address
no shutdown
DellEMC(conf-if-vl-100)#
show vlan
Display the current VLAN configurations on the switch.
S6000
Syntax
show vlan [brief | id vlan-id | name vlan-name]
Parameters
brief (OPTIONAL) Enter the keyword brief to display the following information:
● VLAN ID
● VLAN name (left blank if none is configured)
● Spanning Tree Group ID
● MAC address aging time
● IP address
id vlan-id (OPTIONAL) Enter the keyword id then a number from 1 to 4094. Only
information on the VLAN specified is displayed.
name vlan-name (OPTIONAL) Enter the keyword name then the name configured for the VLAN.
Only information on the VLAN named is displayed.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
910 Layer 2