CLI Guide
metric
metric-
value
(OPTIONAL) Assign a value to the redistributed route. The range is from 0 to
16777215. The default is 0. Use a value that is consistent with the destination
protocol.
metric-type
{external |
internal}
(OPTIONAL) The external link type associated with the default route advertised
into a routing domain. Specify one of the following:
● external
● internal
level-1 (OPTIONAL) Routes are independently redistributed into IS-IS as Level 1 routes.
level-1-2 (OPTIONAL) Routes are independently redistributed into IS-IS as Level-1-2 routes.
level-2 (OPTIONAL) Routes are independently redistributed into IS-IS as Level 2 routes.
This setting is the default.
route-map
map-
name
(OPTIONAL) If you do not enter the route-map argument, all routes are
redistributed. If a map-name value is not specified, no routes are imported.
Defaults
● metric metric-value = 0
● metric-type= internal; level-2
Command Modes
● ROUTER ISIS (for IPv4)
● CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.12.0 Introduced on the S4810.
7.5.1.0 Added support for IPv6 ISIS.
6.3.1.0 Introduced.
Usage
Information
To redistribute a default route (0.0.0.0/0), configure the default-information originate
command.
Changing or disabling a keyword in this command does not affect the state of the other command
keywords.
When an LSP with an internal metric is received, the Dell EMC Networking OS considers the route cost
while considering the advertised cost to reach the destination.
Redistributed routing information is filtered with the distribute-list out command to ensure that
the routes are properly passed to the receiving routing protocol.
868 Intermediate System to Intermediate System (IS-IS)