CLI Guide

ipv6 nd disable-reachable-timer
Keep the learnt neighbor discovery entries stateless so that the entries do not time out.
Syntax
ipv6 nd disable-reachable-timer
To restore to default, use the no ipv6 nd disable-reachable-timer command.
Default Disabled
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.11.0.1 Introduced on the S3100 series, S3048–ON, S4048–ON, S4048T-ON, S4810,
S4820, S5000, S6000, S6010–ON, S6000–ON, S6100–ON, Z9100–ON, C9010,
Z9500, MXL, and FN IOM.
ipv6 nd dns-server
Configures Recursive DNS Server (RDNSS) addresses to be distributed via IPv6 router advertisements to an IPv6 device.
Syntax
ipv6 nd dns-server {ipv6-RDNSS-address} {lifetime | infinite}
To remove the IPv6 RDSS configuration, use no ipv6 nd dns-server {ipv6-RDNSS-address}
{lifetime | infinite}
Parameters
ipv6-RDNSS-
address
Enter the IPv6 Recursive DNS Server’s (RDNSS) address. You can specify up to 4
IPv6 RDNSS server addresses.
lifetime Enter the lifetime in seconds. The amount of time the IPv6 host can use the IPv6
RDNSS address for name resolution. The range is 0 to 4294967295 seconds.
When you specify the maximum lifetime value of 4294967295 or infinite, the
lifetime does not expire. A value of 0 indicates to the host that the RDNSS address
should not be used. You must specify a lifetime using the lifetime or
infinite parameter.
infinite Enter the keyword infinite to specify that the RDNSS lifetime does not expire.
Defaults Not Configured
Command Modes INTERFACE CONFIG
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.5(0.0) Introduced on the Z9000, S6000, S4810, S4820T, and MXL..
806 IPv6 Basics