CLI Guide

IPv6 Basics
IPv6 basic commands are supported on the Dell EMC Networking OS.
NOTE: For information about the Dell EMC Networking OS version and platform that supports IPv6 in each software
feature, see the IPv6 Addressing section in the Dell EMC Networking OS Configuration Guide.
Topics:
• cam-ipv6 extended-prefix
• clear ipv6 route
• maximum dynamic-routes-ipv6
• show cam-ipv6 extended-prefix
• ipv6 unicast-host-route
• ipv6 nd disable-reachable-timer
• ipv6 nd dns-server
• ipv6 nd reachable-time
• ipv6 route
• show ipv6 management-route
• show ipv6 route
cam-ipv6 extended-prefix
Enable LPM partitioning to support IPv6 /65 to /128 route prefixes to be stored in Partition 1.
S6000
Syntax
cam-ipv6 extended-prefix <Max-IPv6-prefixes>
To remove LPM partitioning configuration, use no cam-ipv6 extended-prefix.
Parameters
Max-IPv6-Prefix Maximum number of IPv6 prefixes in the mask length of /65 to /128. The possible
values are 1024, 2048, and 3072.
Defaults LPM is not partitioned with Partition 1 and therefore /65 to /128 prefixes are not converted to /64
prefixes and are installed and saved in LPM. All the packets for those routes traverse through the default
route path.
Command Modes CONFIGURATION
Command
History
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048–ON.
9.8(0.0P2) Introduced on the S3048–ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.3(0.1) Introduced on the S6000.
24
802 IPv6 Basics