CLI Guide
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.0 Added the ingress-port parameter for the S4810.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage
Information
By default, Dell EMC Networking OS distributes incoming traffic based on a hash algorithm using the
following criteria:
● IP source address
● IP destination address
● VLAN
● Protocol
● TCP/UDP source port
● TCP/UDP destination port
load-balance hg
Choose the traffic flow parameters the hash calculation uses while distributing the traffic across internal higig links.
Syntax
[no] load-balance hg {ip-selection | ipv6-selection [source-ip | source-
ipv6 | source-port-id | source-module-id | dest-ip | dest-ipv6 | dest-port-
id | dest-module-id | protocol | vlan | L4-source-port | L4-dest-port ] |
mac [source-mac | source-port-id | source-module-id | dest-mac | dest-port-
id | dest-module-id | vlan | ethertype | source-dest-mac ] | tunnel [ipv4-
over-ipv4 | ipv4-over-gre-ipv4 | mac-in-mac]}
Parameters
{{ip-selection|
ipv6-selection
[
source-ip
|
source-ipv6
|
source-port-id
|
source-module-id
|
dest-ip
|
dest-
ipv6
|
dest-port-
id
|
dest-module-
id
|
protocol
|
To use IPv4 key fields in hash computation, enter the keyword ip-selection
then one of the parameters. To use IPv6 key fields in hash computation, enter the
keyword ipv6-selection then one of the parameters.
● source-ip — Use IPv4 src-ip field in hash calculation.
● source-ipv6 — Use IPv6 src-ip field in hash calculation
● source-port-id — Use src-port-id field in hash calculation.
● source-module-id — Use src-module-id field in hash calculation.
● dest-ip — Use IPv4 dest-ip field in hash calculation.
● dest-ipv6 — Use IPv6 dest-ip field in hash calculation
774 IPv4 Routing