CLI Guide

ip host
Assign a name and an IP address to the host-to-IP address mapping table.
S6000
Syntax
ip host name ip-address
To remove an IP host, use the no ip host name [ip-address] command.
Parameters
name Enter a text string to associate with one IP address.
ip address Enter an IP address, in dotted decimal format, to be mapped to the name.
Defaults Not configured.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced for the E-Series.
ip icmp source-interface
Enable the ICMP error and unreachable messages to be sent with the source interface IP address, such as the loopback
address, instead of the hops of the preceding devices along the network path to be used for easy debugging and diagnosis of
network disconnections and reachability problems with IPv4 packets.
Syntax
ip icmp source-interface interface
Parameters
interface Enter one of the following keywords and slot/port or number information:
IPv4 Routing 761