CLI Guide

Field Description
Mode Lists the mode:
● L3 — for Layer 3
● L2 — for Layer 2
Status Displays the status of the port channel.
● down — if the port channel is disabled (shutdown)
● up — if the port channel is enabled (no shutdown)
Uptime Displays the age of the port channel in hours:minutes:seconds.
Ports Lists the interfaces assigned to this port channel.
(untitled) Displays the status of the physical interfaces (up or down).
● In Layer 2 port channels, an * (asterisk) indicates which interface is the primary
port of the port channel. The primary port sends out interface PDU.
● In Layer 3 port channels, the primary port is not indicated.
Example
DellEMC# show interfaces port-channel 1 brief
LAG Mode Status Uptime Ports
1 L2 up 00:00:08 Te 3/1 (Up) *
Te 3/2 (Down)
Te 3/3 (Up)
DellEMC#
Related
Commands
● show lacp — display the LACP matrix.
show port-channel-flow
Display an egress port in a given port-channel flow.
Syntax
show port-channel-flow outgoing-port-channel number incoming-interface
interface {source-ip address destination-ip address} | {source-port number
destination-port number} | {source-mac address destination-mac address
{vlan vlanid | ether-type}}
Parameters
outgoing-port-
channel number
Enter the keywords outgoing-port-channel then the number of the port
channel to display flow information.
● For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 4096.
incoming-
interface
interface
Enter the keywords incoming-interface then the interface type and the
interface information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
source-ip
address
Enter the keywords source-ip then the IP source address in IP address format.
destination-ip
address
Enter the keywords destination-ip then the IP destination address in IP
address format.
source-port
number
Enter the keywords source-port then the source port number. The range is
from 1 to 65536. The default is None.
734 Interfaces