CLI Guide

Version Description
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.9(0.0) Added support to display the interface configurations corresponding to a range of
ports.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S-Series and Z-Series.
Usage
Information
NOTE: This command also enables you to view information corresponding to a range of ports.
● You can specify multiple ports as port-range. For example, if you want to display information
corresponding to all ports between 1 and 4, specify the port range as show interfaces
interface-type 1 - 4.
Example
DellEMC# show interfaces vlan 10
Vlan 10 is up, line protocol is down
Address is 90:b1:1c:f4:99:ce, Current address is 90:b1:1c:f4:99:ce
Interface index is 1107787786
Internet address is not set
Mode of IPv4 Address Assignment: NONE
DHCP Client-ID: 90b11cf499ce
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed auto
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 2d17h26m
Queueing strategy: fifo
Time since last interface status change: 2d17h26m
Input Statistics:
0 packets, 0 bytes
Output Statistics:
0 packets, 0 bytes, 0 underruns
show system stack-unit quad-port-profile
Displays the list of configured and activated dynamic fan-out capable ports.
Syntax
show system [stack-unit-number] quad-port-profile
Parameters
stack-unit-
number
Enter the port number. The range is from 0 to 5.
Command Modes EXEC Privilege
Command
History
Version Description
9.10(0.1) Introduced on the S6010-ON.
9.7(0.0) Introduced on the S6000 and S6000–ON.
Example
Dell#show system stack-unit 0 quad-port-profile
Configured fan out profile ports in stack-unit 0
Configured Activated
0 0
710 Interfaces