CLI Guide

Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
Version 9.4.(0.0) Introduced on the S-Series and Z-Series.
Usage
Information
Use this command on the interfaces where the DHCP clients are connected to forward the packets from
clients to DHCP server and vice-versa.
Example
DellEMC(conf-if-te-1/12)# ip helper-address vrf jay 10.0.0.2
ipv6 helper-address
Configures the IPv6 DHCP helper addresses.
Syntax
[no] ipv6 helper-address [vrf vrf-name] ipv6-address
To delete the IPv6 helper address, use the [no] ipv6 helper-address [vrf vrf-name]
ipv6-address command.
Parameters
vrf vrf-name (Optional) Enter the keyword vrf and then the name of the VRF through which
the host address can be reached.
ipv6-address Enter the keywordipv6–address through which the server address can be
reached.
Default Disabled.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(1.0) Enhanced to support non-default VRF configuration for DHCPv6 helper address.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S6000, S6000–ON, Z9000, and Z9500.
Usage
Information
Use this command on the interfaces where the DHCP clients are connected to forward the packets from
clients to DHCP server and vice-versa.
Example
DellEMC(conf-if-te-1/1)# ipv6 helper-address
X:X:X:X::X IPv6 helper address
VRF VRF name.
Dynamic Host Configuration Protocol (DHCP) 577