CLI Guide

cam-optimization
Optimize CAM utilization for QoS Entries by minimizing require policy-map CAM space.
S6000
Syntax
cam-optimization [qos]
Parameters
qos Optimize CAM usage for QoS.
Defaults Disabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0. Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage
Information
When you enable this command, if a Policy Map containing classification rules (ACL and/or dscp/ ip-
precedence rules) is applied to more than one physical interface on the same port pipe, only a single copy
of the policy is written (only one FP entry is used).
NOTE: An ACL itself may still require more that a single FP entry, regardless of the number of
interfaces. For more information, refer to the “IP Access Control Lists”, “Prefix Lists”, and “Route-
map” sections in the Dell EMC Networking OS Configuration Guide.
cam-threshold
Configure CAM threshold value for sending the syslog message on CAM usage. Configure silence period for stop receiving
syslog message on CAM usage.
Syntax
cam-threshold threshold {default | threshold-percent} silence-period
{default | silence-period-value}
Defaults
Enabled
462 Content Addressable Memory (CAM)