CLI Guide

Example
DellEMC# conf t
DellEMC(conf)# ip community-list cl1
DellEMC(config-community-list)# permit 1000:1
DellEMC(config-community-list)# end
DellEMC# show ip bgp community-list cl1
BGP local RIB : Routes to be Added 0, Replaced 0, Withdrawn 0
BGP local router ID is 192.168.11.5
Status codes: s suppressed, S stale, d dampened, h history, * valid, > best
Path source: I - internal, a - aggregate, c - confed-external, r - redistributed
n - network, D - denied, S - stale
Origin codes: i - IGP, e - EGP, ? - incomplete
Network Next Hop Metric LocPrf Weight Path
*> 55.0.0.0/24 172.16.0.2 0 200 i
DellEMC# show ip bgp 55.0.0.0/24
BGP routing table entry for 55.0.0.0/24
Paths: (1 available, table Default-IP-Routing-Table.)
Not advertised to any peer
Received from :
172.16.0.2 (172.16.0.2) Best
AS_PATH : 200
Next-Hop : 172.16.0.2, Cost : 0
Origin IGP, Metric 4294967295 (Default), LocalPref 100, Weight 0, external
Communities :
200:1 1000:1 3000:1
DellEMC#
show ip bgp dampened-paths
View BGP routes that are dampened (non-active).
S6000
Syntax
show ip bgp [vrf vrf-name] [ipv4 {multicast | unicast} | ipv6 unicast]
dampened-paths
Parameters
vrf vrf-name (OPTIONAL) Enter the keywords vrf and then the name of the VRF to view
routes that are affected by a specific community list corresponding to that VRF.
ipv4 multicast (OPTIONAL) Enter the keyword ipv4 followed by the keyword multicast to
view information related only to ipv4 multicast routes.
ipv4 unicast (OPTIONAL) Enter the keywords ipv4 followed by the keyword unicast to view
information related only to ipv4 unicast routes.
ipv6 unicast (OPTIONAL) Enter the keyword ipv6 followed by the keyword unicast to view
information related only to ipv6 unicast routes.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
Border Gateway Protocol 429