CLI Guide

vrrp-ipv6-group
Assign an interface to a VRRP group.
Syntax
vrrp-ipv6-group vrid
Parameters
vrid Enter the virtual-router ID number of the VRRP group. The VRID range is from 1 to
255.
Defaults Not configured.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
8.4.2.1 The range of valid VRID values on the E-Series when VRF microcode is loaded in
CAM changed from 1 to 15.
8.4.1.0 Introduced on the E-Series, C-Series, and S-Series.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.3.2.0 Introduced on the E-Series.
Usage
Information
The VRRP group only becomes active and sends VRRP packets when you configure a link-local virtual IP
address. When you delete the virtual address, the VRRP group stops sending VRRP packets.
● When you do not load the VRF microcode in the CAM, the VRID for a VRRP group is the same as the
VRID number configured with the vrrp-group or vrrp-ipv6-group commands.
● When you load the VRF microcode in the CAM, the VRID for a VRRP group equals 16 times the vrrp-
group or vrrp-ipv6-group vrid number, plus the ip vrf vrf-id number. For example, if
you load the VRF microcode and you configure the VRRP group as 10 in VRF 2, the VRID for the
VRRP group is (16 x 10) + 2, or 162. This VRID value is used in the lowest byte of the virtual MAC
address of the VRRP group and is also used for VRF routing.
NOTE: For all routers to interoperate, configure the same VRID on neighboring routers (Dell EMC
Networking or non- Networking) in the same VRRP group.
Related
Commands
● virtual-address — assigns up to 12 virtual IP addresses per VRRP group.
Virtual Router Redundancy Protocol (VRRP) 1701