CLI Guide

Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Introduced on the S–Series.
Usage
Information
Use this command to add the IPv4 catch-all route (0.0.0.0/0) in the LPM route forwarding table if it was
deleted using the no ip unknown-unicast command previously. This will be the default configuration
after reload.
ipv6 unknown-unicast
Disable soft forwarding of unknown IPv6 destination packets.
S6000
Syntax
[no] ipv6 unknown-unicast
Defaults Soft forwarding is enabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
Usage
Information
All the default catch-all entries in the longest prefix match (LPM) table collect and transmit all unresolved
IPv6 packets to the CPU, even if they are destined for unknown destinations.
ip http vrf
Configure an HTTP client with a VRF used to connect to the HTTP server.
S6000
Syntax
ip http vrf {management | vrf-name}
To undo the HTTP client configuration, use the ip http vrf command.
Virtual Routing and Forwarding (VRF) 1621