CLI Guide

You can assign an interface to only one uplink-state group. Configure each interface assigned to an
uplink-state group as either an upstream or downstream interface, but not both.
You can assign individual member ports of a port channel to the group. An uplink-state group can contain
either the member ports of a port channel or the port channel itself, but not both.
Example
DellEMC(conf-uplink-state-group-16)# upstream tengigabitethernet 1/10-15
DellEMC(conf-uplink-state-group-16)#
Related
Commands
● downstream — assigns a port or port-channel to the uplink-state group as a downstream interface.
● uplink-state-group — creates an uplink-state group and enables the tracking of upstream links.
1608 Uplink Failure Detection (UFD)