CLI Guide

access-list-name
ipv6 access-list-
name
(Optional) Enter both an IPv4 and IPv6 access list name.
Defaults As above.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.2 Added support for the access parameter.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
The following example specifies the group named harig as a version 3 user requiring both authentication
and encryption and read access limited to the read named rview.
NOTE: The number of configurable groups is limited to 16 groups.
Example
DellEMC# conf
DellEMC(conf)# snmp-server group harig 3 priv read rview
DellEMC#
Related
Commands
● show snmp group — displays the group name, security model, view status, and storage type of each
group.
● show running-config — displays the SNMP running configuration.
snmp-server host
Configure the recipient of an SNMP trap operation.
Syntax
snmp-server host ip-address | ipv6-address [vrf vrf-name] traps | informs
[version 1 | 2c | 3] [auth | no auth | priv] [community-string] [udp-port
port-number] [notification-type]
1460 Simple Network Management Protocol (SNMP) and Syslog