CLI Guide

Example
DellEMC(conf-qos-policy-out) #rate-shape pps 100 100 peak pps 1000 200
DellEMC(conf-qos-policy-out) #rate-shape kbps 1024 100 peak kbps 102400
75
DellEMC(conf-qos-policy-out) # rate-shape 100 100 peak 1000 750
DellEMC(conf-qos-policy-in)#rate-police 100 25 peak 80 500
% Error: Peak rate cannot be less than committed rate.
service-pool wred
A global buffer pool that is a shared buffer pool accessed by multiple queues when the minimum guaranteed buffers for the
queue are consumed can be configured on the S6000 and Z9000 platforms.
Create a global buffer pool that is a shared buffer pool accessed by multiple queues when the minimum guaranteed buffers for
the queue are consumed. S4810, S4820T, S6000, and Z9000 platforms support four global service-pools in the egress direction.
Two service pools are used—one for lossy queues and the other for lossless (priority-based flow control (PFC)) queues. You
can enable WRED and ECN configuration on the global service-pools. You can define WRED profiles and weight on each of the
global service-pools for both lossy and lossless (PFC) service-pools.
Syntax
[No] service-pool wred {green | weight | yellow} {pool0 number/string|
pool1 number/string}
Parameters
service-pool Define the mapping between the service class and policy-based QoS or routing.
wred Specify WRED curve parameters for a queue.
green Specify green (low) drop precedence to a queue.
weight Specify a weight factor to a queue.
yellow Specify yellow (medium) drop precedence to a queue.
pool0 Service-pool buffer 1 (default service-pool for PFC traffic) .
pool1 Service-pool buffer 0 (default service-pool for both lossy and lossless traffic.
traffic).
number Enter a weight for the queue as a number in the range of 1 to 15. This parameter
applies only if you specify the green or yellow drop precedence.
string Enter the WRED profile name. It is a string of up to 32 characters. Or use one of
the five pre-defined WRED profile names. Pre-defined Profiles: wred_drop, wred-
ge_y, wred_ge_g, wred_teng_y, wred_teng_. This parameter applies only if you
specify a weight factor.
Default All queues on backplane ports operate in tail-drop (best-effort traffic) mode by default. There is no
default WRED green or yellow profile. The default weight is 0.
Command Modes CONFIGURATION mode
Command
History
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.7(0.0) Introduced on the S6000-ON.
9.3.0.0 Introduced on the S6000 and Z9000 platforms
Usage
Information
You can configure only service pools 0 and 1 because the Dell EMC Networking OS uses only these two
service pools. The pool, service0, is used for lossy queues and the pool, service1, is used for lossless
(PFC) queues in all the platforms.
1262 Quality of Service (QoS)