CLI Guide

3 3
4 4
5 5
6 6
7 7
Defaults none
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
Usage
Information
The dot1p-priority command changes the priority of incoming traffic on the interface. The system
places traffic marked with a priority in the correct queue and processes that traffic according to its
queue.
When you set the priority for a port channel, the physical interfaces assigned to the port channel are
configured with the same value. You cannot assign the dot1p-priority command to individual
interfaces in a port channel.
rate police
Police the incoming traffic rate on the selected interface.
Syntax
rate police [kbps] committed-rate [burst-KB] [peak [kbps] peak-rate [burst-
KB]] [vlan vlan-id]
Parameters
kbps Enter the keyword kbps to specify the rate limit in Kilobits per second (Kbps). The
range is from 0 to 40000000. The default granularity is Megabits per second
(Mbps).
Quality of Service (QoS) 1215