CLI Guide

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.2.1.0 Increased number of VLANs on ExaScale to 4094 (was 2094).
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command
Related
Commands
telnet — telnet to another device.
ip tftp vrf
Configures an TFTP client with a VRF that is used to connect to the TFTP server.
Syntax
ip tftp [vrf vrf-name]
To undo the TFTP client configuration, use the no ip tftp [vrf vrf-name] command.
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to specify the VRF that is
used by the TFTP client.
Defaults Disabled
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.4.(0.0) Introduced on the S-Series and Z9000.
Usage
Information
Use this command to make the TFTP clients VRF aware. The VRF name that you specify is used by the
TFTP client to reach the TFTP server. If no VRF is specified, then the default VRF is used.
Related
Commands
● ftp-server topdir — sets the directory to be used for incoming FTP connections.
● ftp-server username — sets a username and password for incoming FTP connections.
Control and Monitoring 109