Users Guide

23 UDP packets dropped
0 sFlow samples collected
stack-unit 1 Port set 0
Hu 1/49: configured rate 131072, actual rate 131072
Tf 1/1: configured rate 32768, actual rate 32768
Displaying Show sFlow on an Interface
To view sFlow information on a specific interface, use the following command.
● Display sFlow configuration information and statistics on a specific interface.
EXEC mode
show sflow interface interface-name
The following example shows the show sflow interface command.
DellEMC#show sflow interface twentyFiveGigE 1/1
Te 1/1/1
sFlow type :Ingress
Configured sampling rate :16384
Actual sampling rate :16384
Counter polling interval :20
Extended max header size :128
Samples rcvd from h/w :0
The following example shows the show running-config interface command.
DellEMC#show running-config interface twentyFiveGigE 1/1
!
interface twentyFiveGigE 1/1
no ip address
switchport
sflow ingress-enable
sflow sample-rate 8192
no shutdown
Displaying Show sFlow on a
To view sFlow statistics on a specified Stack-unit, use the following command.
● Display sFlow configuration information and statistics on the specified interface.
EXEC mode
show sflow stack—unit slot-number
DellEMC#show sflow Stack-unit 1
1
Samples rcvd from h/w :0
Total UDP packets exported :0
UDP packets exported via RPM :0
UDP packets dropped :36
Configuring Specify Collectors
The sflow collector command allows identification of sFlow collectors to which sFlow datagrams are forwarded.
You can specify up to two sFlow collectors. If you specify two collectors, the samples are sent to both.
● Identify sFlow collectors to which sFlow datagrams are forwarded.
CONFIGURATION mode
806
sFlow