Users Guide

Table 48. Standard and Compressed Configurations
Uncompressed Compressed
!
interface Vlan 5
tagged tw 1/1
no ip address
shutdown
!
interface Vlan 100
no ip address
no shutdown
!
interface Vlan 1000
ip address 1.1.1.1/16
no shutdown
Uncompressed config size – 52 lines
write memory compressed
The write memory compressed CLI will write the operating configuration to the startup-config file in the compressed mode. In
stacking scenario, it will also take care of syncing it to all the standby and member units.
The following is the sample output:
DellEMC#write memory compressed
!
Jul 30 08:50:26: %STKUNIT0-M:CP %FILEMGR-5-FILESAVED: Copied running-config to startup-
config in flash by default
copy compressed-config
Copy one file, after optimizing and reducing the size of the configuration file, to another location. Dell EMC Networking OS
supports IPv4 and IPv6 addressing for FTP, TFTP, and SCP (in the hostip field).
OUI on 25G and 50G Interfaces
When you connect the system to another device using a 25G or 50G interface, the organizationally unique identifier (OUI) of
the local interface must match with the OUI of the peer interface for autonegotiation to work correctly.
You can set the OUI of the local interface manually using the oui command. This command is only available on 25G and 50G
interfaces.
When you apply an OUI to a 25G or 50G interface, the same OUI is applied to all other fanned-out interfaces on the same
physical port.
Configuring OUI on 25G and 50G Interfaces
To set the OUI on a 25G or a 50G interface, use the following commands:
To configure OUI, use the following commands.
● Change the OUI of an interface:
INTERFACE mode
Interfaces
403