Users Guide

● Create an aggregate entry in the BGP routing table.
CONFIG-ROUTER-BGP mode
aggregate—address address-mask
Use the aggregate-address command without any keywords to create an aggregate entry if any specific BGP routes are
available in the specified range.
DellEMC# configure terminal
DellEMC(conf)# router bgp 100
DellEMC(conf-router_bgp)# aggregate-address 10.1.1.0/24
DellEMC(conf-router_bgp)# exit
DellEMC(conf)#
Following is the sample output of show ip bgp command.
DellEMC# show ip bgp
BGP local RIB : Routes to be Added 0, Replaced 0, Withdrawn 0
BGP local router ID is 30.30.30.30
Status codes: s suppressed, S stale, d dampened, h history, * valid, > best
Path source: I - internal, a - aggregate, c - confed-external, r - redistributed
n - network, D - denied, S - stale
Origin codes: i - IGP, e - EGP, ? - incomplete
Network Next Hop Metric LocPrf Weight Path
*>r 3.3.3.0/24 0.0.0.0 0 32768 ?
s>r 10.1.1.0/30 0.0.0.0 0 32768 ?
*>r 30.30.30.30/32 0.0.0.0 0 32768 ?
*>a 10.1.1.0/24 0.0.0.0 32768 ?
Suppressing BGP aggregate routes
The routes that are suppressed are not advertised to any of the BGP neighbors. You can suppress the aggregate routes using
the suppress-map or summary-only options in the aggregate-address configuration. To suppress the advertisement
of the aggregate routes using BGP, use the following commands.
● Create an aggregate entry and suppress the advertisement of specific routes to all neighbors.
CONFIG-ROUTER-BGP mode
aggregate—address address-mask summary-only
● Create an aggregate entry and suppress the advertisement of specific routes.
CONFIG-ROUTER-BGP mode
aggregate—address address-mask suppress-map map-name
The suppress-map keyword creates the aggregate route but suppress the advertisement of specified routes. The routes
that are suppressed are not advertised to the neighbors. You can use match clause of route maps to selectively suppress
the specific route from the aggregate routes.
Following is the sample configuration to suppress the advertisement of specific aggregate routes.
DellEMC# configure terminal
DellEMC(conf)# router bgp 100
DellEMC(conf-router_bgp)# aggregate-address 10.1.1.0/24 suppress-map map1
DellEMC(conf-router_bgp)# exit
DellEMC(conf)#
The route-map named map1 can have any action such as permit and sequence number configured, so that the advertisement
of aggregate routes can be suppressed based on the set action in the route-map.
Following is the sample configuration to suppress the advertisement of specific aggregate routes to all neighbors.
DellEMC# configure terminal
DellEMC(conf)# router bgp 100
DellEMC(conf-router_bgp)# aggregate-address 10.1.1.0 255.255.255.0 summary-only
DellEMC(conf-router_bgp)# exit
DellEMC(conf)#
Border Gateway Protocol (BGP)
195