Deployment Guide

Fields Description
Interface Displays type of interface and the associated slot and port number.
IP-Address Displays the IP address for the interface, if configured.
Ok? Indicates if the hardware is functioning properly.
Method Displays “Manual” if the configuration is read from the saved configuration.
Status States whether the interface is enabled (up) or disabled (administratively down).
Protocol States whether IP is enabled (up) or disabled (down) on the interface.
Example (Brief)
DellEMC# show ip interface brief
Interface IP-Address OK? Method Status
Protocol
TenGigabitEthernet 1/1/1 unassigned NO Manual administratively down
down
TenGigabitEthernet 1/1/2 unassigned NO Manual administratively down
down
TenGigabitEthernet 1/1/3 unassigned YES Manual up
up
TenGigabitEthernet 1/1/4 unassigned YES Manual up
up
TenGigabitEthernet 1/2/1 unassigned YES Manual up
up
TenGigabitEthernet 1/2/2 10.10.10.1 YES Manual up
up
TenGigabitEthernet 1/2/3 unassigned NO Manual administratively down
down
show ip management-route
View the IP addresses assigned to the Management interface.
Syntax
show ip management-route [all | connected | summary | static]
Parameters
all (OPTIONAL) Enter the keyword all to view all IP addresses assigned to all
Management interfaces on the switch.
connected (OPTIONAL) Enter the keyword connected to view only routes directly
connected to the Management interface.
summary (OPTIONAL) Enter the keyword summary to view a table listing the number of
active and non-active routes and their sources.
static (OPTIONAL) Enter the keyword static to view non-active routes also.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
780 IPv4 Routing