CLI Guide

Related
Commands
● interface port-channel — create a port channel interface.
● interface vlan — create a VLAN.
● show ip interface — display the interface routing status. Add the keyword brief to display a table of
interfaces and their status.
speed (for 10/100/1000/10000 interfaces)
Set the speed for 10/100/1000/10000 interfaces. Set both sides of a link to the same speed (10/100/1000/10000) or to auto or
the link may not come up.
Syntax
speed {10 | 100 | 1000 | 10000 | auto}
To return to the default setting, use the no speed {10 | 100 | 1000 | 10000} command.
Parameters
10 Enter the keyword 10 to set the interface’s speed to 10 Mb/s.
NOTE: This interface speed is not supported on the LC-EH-GE-50P or the
LC-EJ-GE-50P card. If the command is entered for these interfaces, an error
message appears.
100 Enter the keyword 100 to set the interface’s speed to 10/100 Mb/s.
NOTE: When this setting is enabled, only 100Base-FX optics are supported on
the LC-EH-GE-50P or the LC-EJ-GE-50P card.
1000 Enter the keyword 1000 to set the interface’s speed to 1000 Mb/s. Auto-
negotiation is enabled. For more information, refer to negotiation auto.
NOTE: When this setting is enabled, only 1000Base-FX optics are supported
on the LC-EH-GE-50P or the LC-EJ-GE-50P card.
10000 Enter the keyword 10000 to set the interface’s speed to 10000 Mb/s. Auto-
negotiation is enabled. For more information, refer to negotiation auto.
auto Enter the keyword auto to set the interface to auto-negotiate its speed. Auto-
negotiation is enabled. For more information, refer to negotiation auto.
Defaults auto
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14.1.2 Introduced the option 10000 speed setting on the S5048F-ON.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Added support for fanned–out 1 Gigabit SFP port.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Supported on LC-EH-GE-50P or the LC-EJ-GE-50P cards.
8.1.1.0 Introduced on the E-Series.
670 Interfaces