CLI Guide

Version Description
7.7.1.0 Introduced on the C-Series.
deny bandwidth
Enables you to specify link band width extended-community attribute as the matching criteria to deny incoming or outgoing
traffic.
Syntax
deny bandwidth
To disable this setting, enter the no deny bandwidth command.
Parameters
bandwidth Enter the keyword bandwidth to specify extended-community attribute as the
matching criteria for denying traffic. The range is from 0 to 102400.
Defaults N/A
Command Modes EXTENDED COMMUNITY LIST
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S-Series and Z9500.
Related
Commands
● permit bandwidth – specify link band width extended-community attribute as the matching criteria to
permitting incoming or outgoing traffic.
debug ip bgp
Display all information on BGP, including BGP events, keepalives, notifications, and updates.
Syntax
debug ip bgp [ vrf vrf-name | A.B.C.D | X:X:X:X::X | peer-group peer-group-
name] [in | out]
To disable all BGP debugging, use the no debug ip bgp command.
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to debug BGP information
corresponding to that VRF.
NOTE: Use this attribute to debug BGP protocol operations corresponding to
either a default or non-default VRF.
A.B.C.D Enter the IPv4 address of the neighbor in dotted decimal format.
X:X:X:X::X (OPTIONAL) Enter an IPv6 address.
Border Gateway Protocol 365