CLI Guide

propagates at an average rate that is less than or equal to the committed rate, it is considered to be
green-colored or coded. When the transmitted traffic falls below the committed rate, the bandwidth,
which is not used by any traffic that is traversing the network, is aggregated to form the committed burst
size. Traffic is considered to be green-colored up to the point at which the unused bandwidth does not
exceed the committed burst size.
Related
Commands
● rate shape — shapes traffic output as part of the designated policy.
● qos-policy-output — creates a QoS output policy.
service-policy input
Apply an input policy map to the selected interface.
S3048–ON
Syntax
service-policy input policy-map-name [layer2]
To remove the input policy map from the interface, use the no service-policy input policy-
map-name [layer2] command.
Parameters
policy-map-name Enter the name for the policy map in character format (32 characters maximum).
You can identify an existing policy map or name one that does not yet exist.
layer2 (OPTIONAL) Enter the keyword layer2 to specify a Layer 2 Class Map. The
default is Layer 3.
Defaults Layer 3
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 E-Series Only: Expanded to add support for Layer 2.
6.1.1.1 Introduced on the E-Series.
1238 Quality of Service (QoS)