Users Guide

QSFP 49/1 Voltage Low Alarm threshold = 2.970V
QSFP 49/1 Bias Low Alarm threshold = 0.500mA
QSFP 49/1 RX Power Low Alarm threshold = -13.5067dBm
===================================
QSFP 49/1 Temp High Warning threshold = 70.000C
QSFP 49/1 Voltage High Warning threshold = 3.465V
QSFP 49/1 Bias High Warning threshold = 9.500mA
QSFP 49/1 RX Power High Warning threshold = 2.4000dBm
QSFP 49/1 Temp Low Warning threshold = 0.000C
QSFP 49/1 Voltage Low Warning threshold = 3.135V
QSFP 49/1 Bias Low Warning threshold = 1.000mA
QSFP 49/1 RX Power Low Warning threshold = -9.5001dBm
===================================
QSFP 49/1 Temperature = 25.781C
QSFP 49/1 Voltage = 3.320V
QSFP 49/1 TX1 Bias Current = 7.980mA
QSFP 49/1 TX2 Bias Current = 7.644mA
QSFP 49/1 TX3 Bias Current = 7.648mA
QSFP 49/1 TX4 Bias Current = 7.852mA
QSFP 49/1 RX1 Power = -1.0265dBm
QSFP 49/1 RX2 Power = -0.3021dBm
QSFP 49/1 RX3 Power = -0.4779dBm
QSFP 49/1 RX4 Power = -0.6900dBm
QSFP 49/1 TX1 Power = not available
QSFP 49/1 TX2 Power = not available
QSFP 49/1 TX3 Power = not available
QSFP 49/1 TX4 Power = not available
Related
Commands
● interface — configure a physical interface on the switch.
● show ip interface — display Layer 3 information about the interfaces.
show range
Display all interfaces configured using the interface range command.
Syntax
show range
Command Modes INTERFACE RANGE (config-if-range)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(1.0) Introduced on the S5048F–ON.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Interfaces 723