Manualshelf

Users Guide

ManualsBrandsDell ManualsAccess PlatformsOS9
701702703704705706707708709710
OUI is 0x6a737d
Wavelength is 90nm
Interface index is 2103820
Internet address is not set
Mode of IPv4 Address Assignment : NONE
DHCP Client-ID :3417eb373902
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 25000 Mbit
Flowcontrol rx off tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 00:06:57
Queueing strategy: fifo
Input Statistics:
5441807056 packets, 348275680676 bytes
5441806949 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts, 5441798569 Unicasts
25 runts, 0 giants, 0 throttles
77 CRC, 0 overrun, 0 discarded
0 FEC corrected blocks, 0 FEC uncorrected blocks
The following output shows that with FEC is enabled on the system, the FEC error count increases:
DellEMC#$ interfaces twentyFiveGigE 1/50/1
twentyFiveGigE 1/50/1 is up, line protocol is up
Hardware is DellEMCEth, address is 34:17:eb:37:39:02
Current address is 34:17:eb:37:39:02
Pluggable media present, QSFP28 type is 100GBASE-CR4-5M
AutoNegotiation is OFF
Forward Error Correction(FEC) configured is cl74
FEC status is cl74
OUI is 0x6a737d
Wavelength is 90nm
Interface index is 2103820
Internet address is not set
Mode of IPv4 Address Assignment : NONE
DHCP Client-ID :3417eb373902
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 25000 Mbit
Flowcontrol rx off tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 00:07:16
Queueing strategy: fifo
Input Statistics:
6125878165 packets, 392056231756 bytes
6125878043 64-byte pkts, 1 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts, 6125869387 Unicasts
43 runts, 0 giants, 0 throttles
157 CRC, 0 overrun, 0 discarded
56 FEC corrected blocks, 3 FEC uncorrected blocks
Related
Commands
● show interfaces configured – display any interface with a non-default configuration.
● show ip interface – display Layer 3 information about the interfaces.
● show range – display all interfaces configured using the interface range command.
show interfaces configured
Display any interface with a non-default configuration.
Syntax
show interfaces configured
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
708 Interfaces