Users Guide

FEC status is cl74
OUI is 0x6a737d
DellEMC(conf-if-fi-1/51/1)#do show int fi 1/51/1
fiftyGigE 1/51/1 is up, line protocol is up
Hardware is DellEMCEth, address is 34:17:eb:37:0c:02
Current address is 34:17:eb:37:0c:02
Pluggable media present, QSFP28 type is 2x50GBASE-CR2-1M
AutoNegotiation is ON
Forward Error Correction(FEC) configured is cl108
FEC status is cl108
Related
Commands
fec default — sets the FEC to default value.show config — displays the interface configuration.
flowcontrol
Control how the system responds to and generates 802.3x pause flow control frames.
Syntax
flowcontrol {rx {off | on} tx {off | on} [negotiate | pause-threshold value
| resume-offset value] | [monitor session-ID]}
To return to the default, use the no form of this command.
Parameters
rx on Enter the keywords rx on to process the received flow control frames on this
port.
NOTE: Flow-control packets are mirrored only when flow-control rx is
enabled on an interface.
rx off Enter the keywords rx off to ignore the received flow control frames on this
port.
tx on Enter the keywords tx on to send control frames from this port to the connected
device when a higher rate of traffic is received.
tx off Enter the keywords tx off so that flow control frames are not sent from this
port to the connected device when a higher rate of traffic is received.
pause-threshold Enter the buffer threshold limit for generating PAUSE frames.
resume-offset Enter the offset value for generating PAUSE frames to resume traffic.
negotiate (Optional) Enter the keyword negotiate to enable the pause-negotiation with
the egress port of the peer device. If the negotiate command is not used,
pause-negotiation is disabled. 40-gigabit Ethernet interfaces do not support pause-
negotiation
monitor Enter the keyword monitor then the session-ID to enable mirror flow control
frames on the interface. The range is from 0 to 65535.
Defaults rx off tx off
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(1.0) Introduced on the S5048F–ON.
9.11(0.0) Added support for monitor session.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
Interfaces 673