Users Guide

Example
DellEMC(conf)# load-balance flexhash ipv4 ip-proto 1 desc offset1 1 offset2
2
lacp fast-switchover
Cause the physical ports to be aggregated faster by configuring this capability in a port-channel on both the nodes that are
members of a port-channel.
Syntax
lacp fast-switchover
To disable the capability of faster aggregation of the member ports of a LAG or a port-channel bundle,
use the no version of this command.
Defaults Not configured
Command Modes INTERFACE (conf-if-po-number)
Command
History
Version Description
9.12(1.0) Introduced on the S5048F–ON.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.3(0.0) Introduced on the S6000.
9.2(1.0) Introduced on the Z9500.
Usage
Information
You can configure the optimal switchover functionality for LACP. This command applies to dynamic port-
channel interfaces only. When applied on a static port-channel, this command has no effect
If you configure the optimized booting-time capability and perform a reload of the system, the LACP
application sends PDUs across all the active LACP links immediately.
Related
Commands
show lacp — displays the LACP configuration.
encapsulation dot1q
Configures lite-subinterfaces.
Syntax
encapsulation dot1q vlan-id
To remove a previously configured lite-subinterface, use the no encapsulation dot1q vlan-id
command.
Parameters
dot1q vlan-id Enter the keyword dot1q followed by the VLAN ID to which the host belongs. The
range is from 1 to 4094. A lite subinterface is considered as a Layer 3 port property
and is synchronous with the existing rules of applying Layer 2 or Layer 3 properties
to an interface.
Command Modes
INTERFACE
Command
History
Version Description
9.12.1.0 Introduced on the S5048F–ON.
9.10(0.1) Introduced on the S6010-ON and S4048-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
Flex Hash and Optimized Boot-Up 595