Users Guide

Version Description
9.9(0.0) Added support to display the interface configurations corresponding to a range of
ports.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
You can use this command even without enabling DCB.
Example
(Summary)
DellEMC#show interfaces twentyFiveGigE 1/13 pfc statistics
Interface twentyFiveGigE 1/13
Interface Priority Rx XOFF Frames Rx Total Frames Tx Total Frames
---------------------------------------------------------------------
Tf 1/13 P0 0 0 0
Tf 1/13 P1 0 0 0
Tf 1/13 P2 0 0 0
Tf 1/13 P3 0 0 0
Tf 1/13 P4 0 0 0
Tf 1/13 P5 0 0 0
Tf 1/13 P6 0 0 0
Tf 1/13 P7 0 0 0
DellEMC(conf)#
ETS Commands
The following ETS commands are supported on the Dell EMC Networking OS.
NOTE:
Before configuring ETS, assign the etsacl space. using the cam-acl l2acl 2 ipv4acl 0 ipv6acl 0
ipv4qos 2 l2qos 0 l2pt 0 ipmacacl 0 vman-qos 0 fcoeacl 2 etsacl 1 iscsi 2 command.
dcb-enable
Enable data center bridging.
Syntax
dcb enable[pfc-queues 1–4]
To disable DCB, use the no dcb enable command.
Parameters
pfc-queues Enter the pfc-queue range. To disable DCB, use the no dcb enable command. The
range is from 1 to 4.
Defaults None
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(1.0) Introduced on the S5048F–ON.
486 Data Center Bridging (DCB)