Users Guide

Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.0.2.0 Introduced on the S6000.
Usage
Information
When you enter the reload command and the system reboots, you will not be prompted for a password
to enter the EXEC Privilege mode (normally you are required to enter the enable command).
If your console or Telnet session expires after you used the ignore enable-password command, you are
prompted for an enable password when you re-establish the session
Related
Commands
reload — Exit from this mode and reload FTOS.
ignore startup-config
During a reload, do not load the startup-config file.
Syntax ignore startup-config
Defaults disabled
Command Modes BOOT_USER
Command
History
Version Description
9.12(1.0) Introduced on the S5048F–ON.
9.10(0.0) Introduced on the S6100.
9.8(1.0) Introduced on the Z9100–ON.
9.0.2.0 Introduced on the S6000.
Usage
Information
Use this command if you have authentication procedures in the startup-config other than the enable-
password setting.
interface management ethernet ip address
Assign an IP address to the Management Ethernet interface.
Syntax
[no] interface management ethernet ip address ip-address mask
To delete the IP address, enter no interface management ethernet ip address.
Defaults Not configured.
Command Modes BOOT_USER
Command
History
Version Description
9.12(1.0) Introduced on the S5048F–ON.
9.10(0.0) Introduced on the S6100.
9.8(1.0) Introduced on the Z9100–ON.
9.0.2.0 Introduced on the S6000.
336 Boot Command Line Interface