Users Guide

implicit-permit (OPTIONAL) Enter the keyword implicit-permit to change the default action
of the ACL from implicit-deny to implicit-permit (that is, if the traffic does not
match the filters in the ACL, the traffic is permitted instead of dropped).
vlan vlan-id (OPTIONAL) Enter the keyword vlan then the ID numbers of the VLANs. The
range is from 1 to 4094 (you can use IDs from 1 to 4094).
vrf vrf-name (OPTIONAL) Enter the keyword vrf then the ID numbers of the VRFs. The range
is from 1 to 511 (you can use IDs from 1 to 511).
NOTE: When you specify a single VRF, use the name of the VRF instead of the
VRF ID number. Use the VRF ID numbers only when you specify a range of
VRFs.
optimized (OPTIONAL) Enter the keyword optimized to enable ACL optimization
layer3 (OPTIONAL) Enter the keyword layer3 to enable layer 3 mode. It ensures that all
the ACL rules in the access-group are applied only for L3 router packets.
Defaults Not enabled.
Command Modes INTERFACE/VRF MODE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(1.0) Introduced on the S5048F–ON.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.4.(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names
were up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage
Information
You can assign one ingress ACL and one egress ACL to an interface.
NOTE: This command supports Loopback interfaces EE3 and EF series route processor modules
(RPMs). This command does not support Loopback interfaces ED series RPMs and S-Series
Loopback interfaces.
190 Access Control Lists (ACL)