Users Guide

Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Example
DellEMC(conf-if-vrid-4)# show config
vrrp-group 4
virtual-address 119.192.182.124
!
DellEMC(conf-if-vrid-4)#
show vrrp
View the VRRP groups that are active. If no VRRP groups are active, the Dell EMC Networking OS returns No Active VRRP
group.
Syntax
show vrrp [vrrp-id][brief][interface type][ipv6][interface type][vrf vrf-
name]
Parameters
vrrp-id (OPTIONAL) Enter the virtual router identifier for the VRRP group to view only
that group. The range is from 1 to 255.
brief (OPTIONAL) Enter the keyword brief to view a table of information about the
VRRP groups.
interface type (OPTIONAL) Enter the following keywords and the interface information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport] information.
● For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE
then the slot/port[/subport] information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port/subport information.
● For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the
slot/port/subport information.
● For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then
the slot/port information.
● For a VLAN interface, enter the keyword vlan, and then the VLAN ID. The
VLAN ID range is from 1 to 4094.
ipv6 (OPTIONAL) Enter the keyword ipv6 to view only VRRP IPv6 groups.
vrf vrf-name (OPTIONAL) Enter the keyword vrf and then the name of the VRF to view active
VRRP groups corresponding to that VRF.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(1.0) Introduced on the S5048F–ON.
Virtual Router Redundancy Protocol (VRRP) 1709