Users Guide

Version Description
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage
Information
This command enables the SSH server and begins listening on a port. If a port is not specified, listening is
on SSH default port 22.
NOTE: Starting with Dell EMC Networking OS Release 9.2(0.0), SSH server is enabled by default.
Example
DellEMC# conf
DellEMC(conf)# ip ssh server port 45
DellEMC(conf)# ip ssh server enable
DellEMC#
ip ssh server vrf
Configure an SSH server on either a specific VRF or a management VRF.
Syntax
NOTE: Some of the parameters in this command require licensing to access. For more information,
contact your Dell EMC Networking representative.
ip ssh server vrf {any | management | vrf-name}
To disable the SSH server configuration, use the no ip ssh server vrf {management | vrf-
name} command.
Parameters
any Enter the keyword any to enable access to the server from any VRF.
vrf management Enter the keyword vrf followed by the keyword management to configure an
SSH server on a management VRF.
vrf vrf-name Enter the keyword vrf followed by the VRF name to configure an SSH server on
that VRF.
Defaults None
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(1.0) Introduced on the S5048F–ON.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S-Series and Z9000.
Security 1429