Users Guide

DellEMC(conf) #service-pool wred yellow pool0 thresh-3 pool1 thresh-4
DellEMC(conf) #service-pool wred weight pool0 11 pool1 4
DellEMC(conf-wred) #wred thresh-1
DellEMC(conf-wred) #threshold min 100 max 200 max-drop-rate 40
DellEMC(conf-wred) #wred thresh-2
DellEMC(conf-wred) #threshold min 300 max 400 max-drop-rate 80
DellEMC(conf) #service-pool wred green pool0 thresh-1 pool1 thresh-2
DellEMC(conf) #service-pool wred yellow pool0 thresh-3 pool1 thresh-4
DellEMC(conf) #service-pool wred weight pool0 11 pool1 4
DellEMC(conf-wred) #wred thresh-1
DellEMC(conf-wred) #threshold min 100 max 200 max-drop-rate 40
DellEMC(conf-wred) #wred thresh-2
DellEMC(conf-wred) #threshold min 300 max 400 max-drop-rate 80
DellEMC(conf) #service-pool wred green pool0 thresh-1 pool1 thresh-2
DSCP Color Map Commands
The DSCP color map allows you to set the number of specific DSCP values to yellow or red. Traffic marked as yellow delivers
traffic to the egress queue which will either transmit the packet if it has available bandwidth or drop the packet due to no ability
to send. Traffic marked as red (high drop precedence) is dropped.
dscp
Sets the number of specific DSCP values for a color map profile to yellow or red.
Syntax
dscp {yellow | red} [list-dscp-values]
To remove a color policy map profile, use the no dscp {yellow | red} [dscp-list] command.
Parameters
Yellow Enter the yellow keyword. Traffic marked as yellow delivers traffic to the egress
queue which either transmits the packet if it has available bandwidth or drops the
packet due to no ability to send.
Red Enter the red keyword. Traffic marked as red is dropped.
dscp-list Enter a list of IP DSCP values. The dscp-list parameter specifies the full list of IP
DSCP value(s) for the specified color. Each DSCP value in a list is separate values
by commas – no spaces (1,2,3) or indicates a list of values separated by a hyphen
(1-3). Range is 0 to 63.
Defaults None
Command Modes CONFIG-COLOR-MAP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(1.0) Introduced on the S5048F–ON.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
1292 Quality of Service (QoS)