Users Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

1191

Version Description

9.12(1.0) Introduced on the S5048F–ON.

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100-ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100-ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Added support for VRF. Introduced on the S6000-ON.

9.5(0.1) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

8.1.1.0 Introduced on the E-Series.

7.8.1.0 Introduced on the S-Series.

pre- 6.1.1.1 Introduced on the E-Series.

Usage

Information

First-hop routers use this address by to send register packets on behalf of source multicast hosts. The RP

addresses are stored in the order in which they are entered. The RP is chosen based on a longer prefix

match for a group. The RP selection does not depend on dynamic or static RP assignments.

ip pim rp-candidate

Configure a PIM router to send out a Candidate-RP-Advertisement message to the bootstrap (BS) router or define group

prefixes that are defined with the RP address to PIM BSR.

Syntax

ip pim [vrf vrf-name] rp-candidate {interface [priority] [acl-name]}

To return to the default value, use the no ip pim [vrf vrf-name] rp-candidate

{interface [priority]} command.

Parameters

vrf

vrf-name

(OPTIONAL) Enter the keyword vrf followed by the name of the VRF.

NOTE: Applies to specific VRF if input is provided, else applies to Default VRF.

interface

Enter the following keywords and slot/port or number information:

● For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port/subport information.

● For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE

then the slot/port[/subport] information.

● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the

slot/port/subport information.

● For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the

slot/port/subport information.

● For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then

the slot/port information.

● For a Loopback interface, enter the keyword loopback then a number from 0

to 16383.

1192 PIM-Sparse Mode (PIM-SM)