CLI Guide

Version Description
9.10(0.1) Introduced on the S4048T-ON.
9.10(0.0) Introduced on the S6100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(1.0) Introduced on the Z9100-ON.
Example
DellEMC#show system stack-unit 1 fanout configured
Configured fan out ports in stack-unit 1
Mod/Port Mode Speed
1/1 Quad 10G
1/3 Quad 10G
1/5 Quad 10G
1/7 Quad 10G
1/9 Quad 10G
1/11 Quad 10G
1/13 Quad 10G
1/15 Quad 10G
2/1 Quad 10G
2/3 Quad 10G
2/5 Quad 10G
2/7 Quad 10G
2/9 Quad 10G
2/11 Quad 10G
2/13 Quad 10G
2/15 Quad 10G
show interfaces switchport
Display only virtual and physical interfaces in Layer 2 mode. This command displays the Layer 2 mode interfaces’ IEEE 802.1Q
tag status and VLAN membership.
Syntax
show interfaces switchport [interface-type | stack-unit unit-id ]
Parameters
interface-type (OPTIONAL) Enter one of the following keywords and the interface information:
● For a port channel interface, enter the keywords port-channel then a
number.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the stack/slot/port/subport information.
● For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE
then the stack/slot/port/subport information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
stack/slot/port[/subport] information.
● For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the
stack/slot/port/subport information.
● For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then
the stack/slot/port information.
● For a backup interface for this interface, enter the keyword backup.
NOTE: This command also enables you to view information corresponding to a
range of ports.
● For physical interfaces, you can specify multiple ports as slot/port-range.
For example, if you want to display information corresponding to all ports
between 1 and 4, specify the port range as show interfaces interface-
type 1/1 - 4.
● For port–channel interfaces, you can specify multiple ports as port-range.
For example, if you want to display information corresponding to all ports
between 1 and 4, specify the port range as show interfaces port—
channel 1 - 4.
Interfaces
703