CLI Guide

Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Example
DellEMC(conf-if-hu-1/4)# show config
!
interface HundredGigE 1/4
no ip address
mtu 9416
switchport
no shutdown
DellEMC(conf-if-hu-1/4)#
show config (for speed)
Syntax
show config
Command Modes INTERFACE MODE
Command
History
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.3(0.1) Introduced on the S6000.
Usage
Information
In order for the speed information corresponding to an interface to appear in the show command output,
you must first configure the speed of that interface using the speed command.
Example
show config (from INTERFACE RANGE mode)
Display the bulk configured interfaces (interface range).
Syntax
show config
Command Modes CONFIGURATION INTERFACE (conf-if-range)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
Interfaces 689