CLI Guide

forced-slave Force port to slave mode
DellEMC(conf-if-autoneg)#
Example
(Configured)
DellEMC# show interfaces configured
TenGigabitEthernet 1/1/3/4 is up, line protocol is up
Hardware is DellEMCEth, address is 00:01:e8:05:f7:fc
Current address is 00:01:e8:05:f7:fc
Interface index is 474791997
Internet address is 1.1.1.1/24
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 1000 Mbit, Mode full duplex, Master
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interfaces" counters 00:12:42
Queueing strategy: fifo
Input Statistics:
...
User Information
Both sides of the link must have auto-negotiation enabled or disabled for the link to come up.
The following details the possible speed and auto-negotiation combinations for a line between two
10/100/1000 Base-T Ethernet interfaces.
Port 0
● auto-negotiation enabled* speed 1000 or auto
● auto-negotiation enabled speed 100
● auto-negotiation disabled speed 100
● auto-negotiation disabled speed 100
● auto-negotiation enabled* speed 1000 or auto
Port 1
● auto-negotiation enabled* speed 1000 or auto
● auto-negotiation enabled speed 100
● auto-negotiation disabled speed 100
● auto-negotiation enabled speed 100
● auto-negotiation disabled speed 100
Link Status Between Port 1 and Port 2
● Up at 1000 Mb/s
● Up at 100 Mb/s
● Up at 100 Mb/s
● Down
● Down
* You cannot disable auto-negotiation when the speed is set to 1000 or auto.
no port-delay-restore (Interface Mode)
Disables delayed bring up of individual interfaces during switch boot up.
Syntax
no port-delay-restore
Parameters None
Defaults Enabled
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command-Line Reference Guide.
Version Description
9.14(2.3) Introduced on the C9000, S3048-ON, S3100 series, S4048-ON, S4048T-ON,
S5048F-ON, S6000, S6000-ON, S6010-ON, S6100-ON, and Z9100-ON.
684 Interfaces