CLI Guide

intf-type cr2 autoneg
Enable Clause 73 autonegotiation on a 50G CR2 interface.
Syntax
intf-type cr2 autoneg
To disable Clause 73 autonegotiation on a 50G CR2 interface, use the no intf-type cr2 autoneg
command.
Defaults
Not configured
Command Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(0.0) Introduced on the Z9100–ON.
Example
DellEMC(conf-if-fi-1/1/1)#intf-type cr2 autoneg
DellEMC(conf-if-fi-1/1/1)#no intf-type cr2 autoneg
intf-type cr4 autoneg
Set the interface type as CR4 with auto-negotiation enabled. To set the interface type as CR4 with autonegotiation disabled,
use the no intf-type cr4 autoneg command.
Syntax
intf-type cr4 autoneg
Defaults
Enabled on the 100G interfaces
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
You can configure the interface type as CR4 with auto-negotiation enabled. If a DAC cable link is down,
you can resolve the issue by setting the interface type as CR4.
If the CR4 optic fails to come up, use the autoneg option.
On 100-Gigabit Ethernet interfaces, CR4 auto-negotiation is enabled by default.
Related
Commands
● Interfaces — configure a physical interface.
Interfaces 677